Cleaning the water cooler: a step-by-step process
The cooler is a very useful device,It is used not only in office buildings, but also in many private houses and apartments. However, in order for this tool to supply truly clean water, it is necessary to regularly clean it. According to experts, cleaning the water cooler should occur at least once every 3 months. And it's not necessary to call specialists for this, you can do it yourself.
Order and algorithm of actions
Cleaning the water cooler starts with a shutdownapparatus from the power supply network. Then it is installed on a special waterproof mat, after which you need to remove the bottle and drain the old water. Observe the procedure: first the liquid is drained from the hot tap, and then from the cold one. At the next stage, cleaning the water cooler is accompanied by dilution of the drained water with a special disinfectant "BIOR 1". Dosage is approximately 25 milliliters per 1 liter of water. Next, you need to apply a special cleanser "Kremklin" on the parts that are in the drip tray.
After our so-called "repair" coolers forwater is removed by removing the bottle holder (it is necessary to remove it together with the needle) and disinfection of the bottom and walls of the tank. For this, it is not necessary to use any strong or specialized means. It is enough simply to wipe the inside of the container with a lint-free cloth. But in the cooling tank it is quite the opposite - for disinfection it is necessary to apply the prepared solution. We fill it in and let it flow out some part of hot and cold water from the taps. This is to ensure that the watercourses are filled with the right amount of disinfectant solution.
Now cleaning the water cooler willbe carried out with brushes and brushes. They need to process the inside of the holder of the plastic container, separator, watercourses and cooling tank. After that, the holder is again processed (but this time with a napkin) and put back in its place. Special detergent "Kremklin" should also be used to clean the cooler body. Do not forget to process the back of the device and the grille. Now open the hot and cold tap and wait until one of the detergents flows out in turn from each. If possible, also clean the faucets. It is recommended to do this with an Antiklin spray. Use a brush to clean the gutter drains and the front panel.
The final stage
After that, install the faucets in place, put the cleaned bottle with fill the device with clean water.Everything, at this stage, cleaning the water coolersuccessfully completed. Do not forget to connect the device back to the 220V network. Now the next 3 months you can enjoy pure drinking water from your water dispenser.